Knowledge Base

BSPs and drivers

Community resources

Product documentation

Questions?

"Range check failed" in sloginfo

________________________________________________________________________

Applicable Environment

________________________________________________________________________

Topic: "Range check failed" in sloginfo
SDP: 6.4.1
Target: Any supported target

________________________________________________________________________

Solution

________________________________________________________________________

The PCI driver "Range check failed (MEM)" is just a warning. The device has just been inserted, so no base addresses have been assigned. Once a driver performs a

pci_attach_device() the base address registers will be populated.

________________________________________________________________________

NOTE: This entry has been validated against the SDP version listed above. Use caution when considering this advice for any other SDP version. For supported releases, please reach out to QNX Technical Support if you have any questions/concerns.

________________________________________________________________________

Related Attachments

None Found

Please contact us with your questions or concerns.