Knowledge Base

BSPs and drivers

Community resources

Product documentation

Questions?

QConn Target's IP address with spaces confuses GDB

________________________________________________________________________

Applicable Environment

________________________________________________________________________

Topic: QConn target IP address with spaces - causes issues with GDB
SDP: 6.4.1, 6.5.0
Host: Hosts running Momentics IDE versions earlier than 4.7.1

________________________________________________________________________

Issue

________________________________________________________________________

If the IP address entered in a QConn target project contains trailing spaces, this is tolerated by most components: Target Navigator, File System View, etc. You can even run programs. However, if you try to debug programs GDB fails with

"192.168.75.129 : 8000 unknown host

________________________________________________________________________

Recommendation

________________________________________________________________________

The problem is reproducible on QNX 6.4.1 and 6.5, Windows and Linux host. Related problem report is 78531. Issue fixed in IDE 4.7.1.

________________________________________________________________________

NOTE: This entry has been validated against the SDP version listed above. Use caution when considering this advice for any other SDP version. For supported releases, please reach out to QNX Technical Support if you have any questions/concerns.

________________________________________________________________________

Related Attachments

None Found

Please contact us with your questions or concerns.