rtquery

Runs on:

QNX Neutrino

Options:

-1

Query using RIP version 1 instead of RIP version 2.

-a passwd=XXX or -a md5_passwd=XXX|KeyID

Send the query with the specified RIPv2 cleartext or RIPv2 MD5 password.

-n

Display only the numeric network and host numbers instead of both the numeric and symbolic values.

-p

Use the poll command to request full routing information from gated. This is an undocumented extension RIP protocol supported only by gated.

-r addr

Ask about the route to destination addr.

-w timeout

Change the delay for an answer from each host. By default, each host has 15 seconds to respond.

-t op

Change the tracing settings. Requests from processes that aren't running with root privileges, or are on distant networks, are generally ignored by the daemon except for having a message logged in the system log.

on=tracefile

Turn on tracing to the tracefile. The tracefile was either specified when the daemon started, or is the same as a fixed name, typically /etc/routed.trace.

more

Increase the debugging level.

off

Turn off tracing.

dump

Dump the daemon's routing table to the current tracefile.

Description:

The rtquery utility is used to query a RIP network routing daemon, routed or gated, for its routing table by sending a request or poll command. The routing information in any routing response packets returned is displayed numerically and symbolically.

By default, it uses the request command. When -p is specified, rtquery uses the poll command, an undocumented extension to the RIP protocol supported by gated. When querying gated, the poll command is preferred over the request command because the response is not subject to split-horizon and/or Poisoned Reverse, and because some versions of gated do not answer the request command. Although routed doesn't answer the poll command, it recognizes requests coming from rtquery and answers them completely.

The utility is also used to turn tracing on or off in routed.

Based on:

• RFC 1058 Routing Information Protocol, RIPv1
• RFC 1723 Routing Information Protocol, RIPv2